Ritmo ALFA 200 CTB fitting fabrication welder (40-200mm)

The Ritmo ALFA 200 CTB is a workshop butt-fusion welding machine designed to fabricate fittings by joining pipe segments with the help of special jaws for producing ELBOWS up to Ø 200 mm and TEES, CROSSES and WYES (Y) up to Ø 160 mm.


– A machine body with two carriages, one of which driven by a hydraulic system, and two lateral supports with inserts;
– A control panel that features the Easy Life system, thanks to which it is possible to carry out a whole welding cycle in a simple, intuitive and repeatable way, so that the operator’s interference would be reduced to the minimum. An built-in memory allows the machine to store 400 welding cycles (including the set diameters and SDR). It is possible to transfer the welding data to a PC through a serial port (USB adaptor connector available) and data-management software. A printer can be connected to the serial port, to get a welding report at the end of each welding cycle;
– A heating plate with lifting sliding arm;
– An electrically controlled milling cutter for levelling the ends of the pipes and/or fittings with built-in overload cutout and safety microswitch;
– An upper cylinder, to be positioned on the jaws, for welding extra thick pipes and/or whenever it’s necessary to use high pressures.

Standard composition
– Machine body with control panel
– Heating plate
– Milling cutter
– Upper cylinder and service tools

On Request (Accessories)
– Elbows jaws Ø 200 mm with lateral support inserts from Ø 40 to Ø180 mm
– Tees/crosses jaws Ø 160 mm inserts from Ø 63 to Ø140 mm
– Wyes jaws jaws Ø 160 mm inserts from Ø 63 to Ø140 mm
– Right or left special jaws Ø 200 inserts from Ø 40 to Ø 180 mm
– Tool for flange necks

Technical features:

Materials HDPE/PP
Working range ELBOWS
Ø 40 – 200 mm

Ø 63 ÷ 160 mm 2″ IPS ÷ 6” IPS

Welding system EASY LIFE
Memory 400 reports
Power supply 230 V Single Phase 50/60 Hz
Total absorbed power 3500 W
Working Temperature 165° ÷ 280° C
Weight 250 Kg
Dimension 1200x3100x1530 mm